8
©
2014 DJI. All Rights Reserved.
DJI DROPSAFE
User Manual
6. Screw the manifold into the system base (as shown in the figure A below).
7. Ensure the manifold is aligned with the marker on the system base (as shown in the figure B below).
Installing System Base
5. Now the triggering pin is in the ready position. Rotate the hex screwdriver counter-clockwise to remove the
trigger compression tool from the triggering housing unit.
4. It is recommended to test the system before each deployment. Follow the steps below to complete the
test:
(1) Ensure triggering pin is locked in place and system is connected with flight controller. Unscrew the
trigger compression tool for one round (do not unscrew for more than one round, otherwise triggering
pin might be damaged when it is released). Make sure that system LED blinks solid green.
(2) Toggle and hold the "safety switch" on the remote controller to the ON position. Then toggle the
"activation switch" to activate and deploy the system. If the system is deployed successfully, the system
LED blinks solid green and red, otherwise it indicates there is connection error, examine the connection
to re-run the test until the issue is solved.
(3) Power off the flight controller to complete the test. Repeat step 1 to step 3 described in "Setting Up the
System Base for Deployment" to reset the system base.
A
B
