©
2015 DJI. All Rights Reserved.
5
Tools Needed
Preparing for Mounting
Motor Mounting Description
The size of the assembly hole is shown below.
Tools
Use
2.0mm Hex Wrench
For frame and motors installation.
Screw Glue
For fastening screws.
Nylon Cable Tie, Scissors, Diagonal Cutting Pliers
For binding devices and wires.
Foam Double Sided Adhesive Tape
For fixing receiver, controller and
other modules.
Soldering-iron & wires
For connecting ESCs
’
power
cables to bottom board.
The screw size is M3. Mount the motors using appropriate screws.
Note the thread depth and the size of the screws. Using screws that are too long or
too large may damage the motor.
19 mm
16 mm
28.2 mm
40 mm
26 mm
M6
4×M3 Thread depth 3mm
