DJI M100-ZENMUSE X5 Series
Gimbal Installation Kit
8
©
2016 DJI. All Rights Reserved.
3. Connect one end of the 10-pin and 8-pin gimbal cables to the Flight Controller.
4. Arrange the other ends of the gimbal cables near the nose of the aircraft.
5. Hold the new upper plate with the notch facing the left of the aircraft (with its tail facing you). Pull
the Flight Controller's CAN cable, signal cable and power cable through the front wire outlet, and
then pull the Aircraft Status Indicator cable through the back wire outlet.
Flight Controller
10-pin Port
8-pin Port
Aircraft Nose
Flight Controller Signal Cable (6-pin)
Aircraft Status Indicator
Aircraft Status Indicator
Cable (6-pin)
Flight Controller Power Cable (4-pin)
CAN Cable (5-pin)
