3. Ensure that the remote controller firmware is up to date.
4. Connect the CAN cable of the expansion module and make sure
your DJI GO
TM
app is up to date so that the module firmware can
be updated when updating the remote controller firmware.
5. None of the channels is mapped on delivery. Channel mapping
must be completed in the “Tools” page of DJI ASSISTANT
TM
2.
Introduction
The MATRICE
TM
600 Series Remote Controller Channel Expansion
Kit is compatible with the DJI Matrice 600 series remote controller
and includes eight knobs/switches. More control functions will be
available after channel mapping in DJI Assistant 2.
Overview
Channel Expansion Module
1. S1 - S8 Knob / Switch
S1, S2, S7, S8 are knobs, S3, S6 are 3-position switches, and
S4, S5 are spring-loaded switches.
2. Status LED
Solid Green: Functioning normally.
Solid Red: Check if the flat cables inside the RC port module are
connected correctly and the RC firmware is up to date.
LED Off: RC is powered off; if RC is powered on, check if the
CAN cable is in good condition and securely connected.
3. CAN Cable
4. Horizontal Slots
5. Vertical Slots
1
3
2
4
5
