©2014 DJI Innovations. All Rights Reserved.
31 |
3.
Toggle the power switch to right end to switch on the power.
4.
There is a power on indicator beep. If the remote controller is set to be CE compliant, then there will be
one beep while the FCCcompliant version will emit 2 beeps. The power indicator blinks greenquickly
indicating the remote controller and receiver are binding. Once binding is completed, the power
indicator will change to a solid green.
（
1
）
If the low voltage warning alert sounds(refer to the <Remote Controller Power Indicator Status
Information>), please replace batteries as soon as possible.
（
2
）
For long term storage, be sure to remove the batteries from the remote controller.
（
3
）
Dispose the depleted batteries safely.
5.3 Remote Controller Power Indicator Status Information
Power indicator
Sound
Remote Controller State
None
Functioning normally.
None
Establishing a link between the remote controller and the receiver.
B-B-B……
Low voltage (at 3.9V-4.5V), should replace the batteries immediately.
BBBB
Low voltage (lower than 3.9V). The remote controller will automatically
power off. Replace the batteries immediately.
B-B-B……
The remote controllerwill give a visual indication of an alarm after 15
minutesof non-operation. The alarm status will go awayonce you start
operating of the remote controller.
The remote controllerwill blink the LED and sound an alert when the voltage drops below3.9V and
automatically power off after 3 seconds. This process will repeat even if you power cycle the remote
controller. If this low voltage warning occurs during flight, the remote controllerwill automatically
power off causing the aircraft to enter Failsafe mode which cannot be interrupted (refer to <Failsafe
Function> section for details). It is strongly recommended to replace batteries immediatelyif the low
voltage warning(3.9V-4.5V) occurs.
