©2013-2014
DJI Innovations. All Rights Reserved.
4 |
Product Usage Cautions
Please check the following steps carefully before every flight.
1.
Before use of the product, please accept some flight training (Using a simulator to practice flying, getting
instruction from a professional person, etc.).
2.
Check that all parts of the product are in good condition before flight. Do not fly with aging or broken parts.
3.
Check that the propellers and the motors are installed correctly and firmly before flight. Make sure the rotation
direction of each propeller is correct. Do not get close to or even touch the working motors and propellers to
avoid serious injury.
4.
Do not over load the aircraft (The total weight should be less than 1200g).
5.
Make sure that the transmitter battery and the flight battery are fully charged.
6.
Try to avoid interference between the transmitter and other wireless equipment.
7.
Make sure to switch on the transmitter first, and then power on the aircraft before takeoff! Power off the aircraft
first, and then switch off the transmitter after landing!
8.
Fast rotating propellers will cause serious damage and injury. Always fly the aircraft 3m or above away from you
and the unsafe conditions, such as obstacles, crowds, high-voltage lines, etc. FLY RESPONSIBLY.
9.
All parts must be kept out of the reach of children to avoid CHOKE HAZARD; if a child accidentally swallows any
part you should immediately seek medical assistance.
10.
Always keep the compass module away from the magnet. Otherwise it may damage the compass module and
lead the aircraft to work abnormally or even be out of control.
11.
DO NOT use the PHANTOM FC40 transmitter (receiver) with the other third party remote control equipment.
12.
Make sure to use the NAZA-M Assistant Software of 2.20 version (or above) to carry out the firmware upgrade
and parameter configuration.
13.
Built-in ESCs of PHANTOM FC40 ONLY support 3S (11.1V) power supply.
14.
ONLY use the DJI original motor and propeller.
15.
If you want to put the PHANTOM FC40 in a car, please keep it away from the speaker, since the compass
module may be magnetized.
16.
DO NOT use the magnetic screwdriver. Otherwise, keep the screwdriver at least 10cm away from the compass
module, to avoid magnetic interference.
17.
For Mac user, please install the Windows system to run the Assistant Software.
Trademarks
DJI and PHANTOM are registered trademarks of DJI Innovations. Names of product, brand, etc., appearing in this
manual are trademarks or registered trademarks of their respective owner companies. This product and manual are
copyrighted by DJI Innovations with all rights reserved. No part of this product or manual shall be reproduced in any
form without the prior written consent or authorization of DJI Innovations. No patent liability is assumed with respect to
the use of the product or information contained herein.
130.com.ua
Autogood products «130»
