©2014 DJI. All Rights Reserved.
27
Remounting Landing Gear Servo
Remounting servos is not recommended as they come pre-installed.
Instructions
1.
Connect left servo cable near M4 to the “RLG” port near M4 on the center frame, then connect the
“RLG” port near M3 to the “L” port of the landing gear control board using a servo cable.
2.
Connect the right servo cable near M7 to the “R” port of the landing gear control board using a servo
cable.
3.
Pressing the SET button using a pin then power on. You will see a yellow LED beside the SET button
flashes quickly. Wait as servos complete position initialization.
4.
Make sure the arm connecting to the servo is parallel to the link. (Shown in the following Fig).
5.
Assemble the left and right servos to the left and the right parts of the landing gear. Power off.
To right servo
To RLG
of M3
“
”
To receiver channel
To F1 port if use A2
(
)
SET Button
LED
Finished Installation
Servo
Connecting
arm
Link
Recalibrating Servo Travel
Landing gear travel has been pre-calibrated. Mechanical adjustment of gear travel is not recommended.
Instructions
1.
Keep hands away from all mechanisms.
2.
Ensure [R], [L] and [IN] connections are correct.
3.
Keep the whole aircraft off the ground during calibration as landing gear will move.
4.
Press and hold the SET button using a pin while powering on, then release. An LED will flash yellow
quickly. Press the SET button again. Auto calibration will begin and the LED will flash yellow slowly. DO
NOT obstruct any moving parts during auto calibration.
5.
During calibration, the left landing gear will raise and lower, follow by the right landing gear.
6.
After calibration, both left and right landing gears will be lowered and the LED will be a solid green. This
