2
DJMMIG195(GAS/NO GAS)
1. Handle
2. Thermostat control lamp
3. Housing cover
4. Switch for welding current adjustment
5. ON/OFF switch
6. Welding wire speed controller
7. Gas connection point
8. Wheels
9. Wheels
10. Mains plug
11. Earth clamp
12. Hose package
13. Torch
14. Welding nozzle
15. Welding tip
16. Torch trigger
17. Wire brush
18. Welding screen
19. Solid wire(Ø1.0mm, 1kg)
3. Unpacking
●
Open the packaging and remove the device carefully.
●
Remove the packaging material as well as the packaging and
transport bracing (if available).
●
Check if the delivery is complete.
●
Check the device and accessory parts for transport damage.
●
If possible, store the packaging until the warranty period has
expired.
ATTENTION
The device and packaging materials are not toys! Children must not
be allowed to play with plastic bags, film and small parts! There is a
risk of swallowing and suffocation!
4. Intended Use
The flux cored welding set is designed for self-shielding flux cored
welding using suitable wire. The additional application of gas is not
required.
The equipment is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse. The user / operator and
not the manufacturer will be liable for any damage or injuries of any
kind caused as a result of this.
Please note that our equipment has not been designed for use in
commercial, trade or industrial applications. Our warranty will be
voided if the equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
5.Safety Precautions For All Types Of
Welding
5.1
WARNING:AS with all machinery, there are certain hazards
involved with their operation and use. Exercising respect and
caution will considerable lessen the risk of personal injury.
However, if normal safety precautions are overlooked, or ignored,
personal injury to the operator may result.
5.2 General precautions
5.2.1 Burn prevention
Wear protective clothing-gauntlet gloves designed for use in welding,
apron, and protective shoes. Button shirt collar and pocket flaps, and
wear cuffless trousers to avoid entry of sparks and slag. Wear helmet
with safety goggles or glasses with side shields underneath,
appropriate filter lenses or plates(protected by clear cover glass).
This is a must for welding or cutting, (and chipping) to protect the
eyes from avoid oily grasy clothing. A spark may ignite them. Hot
metal such as electrode stubs and workpieces should never be
