1
Inflation Cycle
indicator
3
Patient Compliance
counter reset push button
2
Patient Compliance
counter
4
ON/OFF/RESET
push button
7
Battery Indicator
*Note: Not all VenaFlow Elite
Systems contain a battery
5
S Mode Operation
button
8
S Mode Operation
indicator
6
1
2
3
4
5
6
7
8
1.
Set up Pump
•
Press bed hanger release on the back of the pump and gently pull out
bed hanger hook to the desired width.
•
Connect tubing to the pump. Plug pump into electrical outlet.
2.
Apply Cuff
•
The VenaFlow Elite system will automatically detect the type of cuff and the number of cuffs attached and apply appropriate
pressures. Cuffs must be attached prior to powering on the service.
•
Be sure to secure cuff straps snug but not tight. When using the calf cuff and thigh cuff, rotation of the aircell on the leg does not
affect performance of the system.**
Bed hanger release
Graphical display
Pump indicator lights
(green = on, flashing
red = alarm)
Telescoping bed
hanger hook
Calf or Thigh Cuff:
For varied patient sizes, trim for proper, snug fit.
•
Apply cuff snugly with the tube pointed
toward the foot. Aircell can be orientated to
patient and nursing preference (posterior,
lateral, anterior, or medial).**
Symbol Definitions
Power on/off button and alarm reset
Tube alarm
See VenaFlow Elite System
operator’s manual
Dual calf/thigh
S Mode Operation
Call for service
Battery
Single calf/thigh
Compliance monitor reset
Inflation cycle indication
(Bars indicate cuffs are inflating)
Lock mode
Dual foot
C
Visual only compliance alarm enabled
Visual and audio compliance
alarm enabled
Single foot
Foot Cuff:
•
Apply foot cuff snugly with the aircell
centered on bottom of foot and with the
tube pointed to the left. Foot cuffs are only
for use in standard rapid mode.
Single/Dual Leg
operation indicator
