7
APPLICATION
CALF CUFF APPLICATION
Wrap the cuff around the calf and secure the Velcro to hold it in place.
Make sure the wrap is snug, but not too tight.
Left Leg Pictured
1
When both wraps are secured
on your legs, they should look
like the picture above.
2
TURNING THE DEVICE ON
When the wraps are secured on your
legs PRESS and HOLD the WHITE power
button for about a second until a
single BEEP tone is heard and the light
is illuminated on each unit. To turn the
unit OFF, PRESS and HOLD the WHITE
power button for about a second until
a DUAL BEEP tone is heard and the
light is no longer illuminated.
3
USING THE DEVICE
Don’t be startled. The device will make a “humming” sound when
inflating and squeezing your leg.
THIS IS NORMAL.
The wraps will
inflate once a minute. IF you FEEL air releasing around the legs, this
is normal. This is a function of the device to keep your legs cool.
4
PUMP ALARMS
What to do if the Pump Alarms
Don’t worry, the alarms are there to ensure the units are operating correctly.
BATTERY CRITICAL
If battery voltage drops below a critical level, cycling stops, audible alarm will sound, and UNIT WILL FLASH YELLOW. The Alarm will continue for 30 seconds (unless the unit is powered off) and
automatically turn the unit OFF.
LOW PRESSURE OR LEAK
If the ALARM sounds and the BLUE LED is flashing, the pressure is too LOW.
Make sure wrap is attached snugly to the leg. Turn the Unit OFF and then back ON to reset the alarm.
If the unit continues to ALARM after this step, DO NOT try to fix the device. Contact your local Customer Service representative for a replacement unit.
