3.4.3. Amount of Fog
•
Press Function until the Display shows “Timer out”
•
Use the UP / DOWN keys to set a Output between 1 – 100 %
•
This setup is required if you want to use the Timer function
3.5. Volume Function
If you want to use the volume function for the remote you just have to push volume once on the
machine. Pushing it again will end the Volume Function for the remote.
3.5.1. Amount of Fog
•
Press Function until the Display shows “Volume out”
•
Use the UP / DOWN keys to set a Output between 1 – 100 %
•
This setup is required if you want to use the Volume function
3.6. Remote
•
Press Function until the Display shows “Display Wireless On”
•
Use the UP / DOWN key to turn the remote off / on
3.6.1. Use of the Remote
The Remote has two buttons. Button A turns on the function, button B will turn off the function. The
transmission is able to reach 50 meters.
You can assign 5 remotes to every fog machine.
3.7. Fluid sensor
The Fluid Sensor controls when there is enough fluid left in the tank. You can disable this function:
•
Press Function until the Display shows “Fluid Sensor On”
•
Use the UP / DOWN keys to switch the Sensor on / off
•
Please notice that running low on Fog will cause Damage to the machine.
•
If the Sensor is activated an the fog level is low it will deactivate the pump in between 20
seconds
•
For resetting the Fluid sensor you can push A on the remote or start the fog by DMX.
3.8. Display
Ready to Fog W
W means Wireless receiver is On
Ready to Fog S
S means Fluid Sensor is on
Ready to Fog WS
WS means both, Wireless receiver and Fluid sensor are turned on
Ready to Fog
means both, Wireless receiver and Fluid sensor are turned off
7 / 12
