MSD/PT0600/200 - Technical Reference Manual
17
10. Software Upgrade
To upgrade the MSD with the latest software ver-
sions, connect the RS232 port of the MSD (found
on the rear of the unit) to a PC via the COM1 or
COM2 port.
New software direct from DK-Audio will be sup-
plied on a standard HD floppy disk or may also be
retrieved directly from the Internet at the
DK-Audio website www.dk-audio.com.
10.1 COM Port Selection
The COM port you wish to use to communicate
with the MSD must be selected on your PC. If you
use COM1, type “SET MSD-LOAD=1” at the DOS-
PROMPT. If you use COM2, type “SET MSD-
LOAD=2”. If a COM port has not been set the
update program will abort.
The command “SET MSD-LOAD” is valid only for
the actual DOS-box. This means that the update
program must be executed from the same DOS-
box as the SET-command without prior closing.
10.2 Update Procedure
While in the DOS-PROMPT mode in the correct
directory for MSD update software (for example
directory C:\) type “xxxx.BAT” and then
[ENTER]
.
This will download the new software from the PC to
the MSD. The new software version number will be
shown in the INFO menu.
Make sure that you do not strike any key on the
MSD while the PC is downloading software.
CAUTION!
Do not interrupt the program while
downloading to the MSD, as this may cause
damage to the software. It is therefore advisable
to shut down all other programs during down-
load.
Summary of Contents for PTO200C
