6
OPERATION
1. Fill the stainless steel tank with cleaning solution; Plug the power lead into
grounded outlet; Turns on the switch on the side of the ultrasonic cleaner , After
power-on, the LCD screen displays the preset temperature (25
℃
in default), actual
environmental temperature, preset time - (3 minutes in default), actual time,
frequency and power ratio.
2.
Ultrasonic Frequency Setting:
Press the ultrasonic frequency switch to select the
ultrasonic frequency you need (40Khz, 80Khz, Dual frequency 40Khz &80Khz )
*
Note:
Only after preset the cleaning time in frequency 40Khz and cleaning time in
frequency 80Khz, then you can select dual frequency (40Khz& 80Khz)
3.
Time setting:
Press the ultrasonic time “
+/- “
buttons once to add or decrease
one second cleaning time; keep pressing the ultrasonic “
+/- “
button to make the
time setting to be added or decreased by minute. If preset time display “Cont”,
then the machine ultrasonic time is in “always on” mode.
4.
Temperature Setting:
1
℃
can be added or decreased by pressing the
temperature “
+/-
” button by once, and the preset temperature can be added or
decreased continuously by keeping pressing the heating “
+/-
” button.
NOTE: Do not pour water out until it’s cooling, because of hot water will hurt you
and also empty burn will damage the machine itself.
5.
Ultrasonic Power Adjustable :
Press the two buttons “
Ultrasonic Power
“
and “
Ultrasonic Power Switch - ”
at the same time , the power percent
display start flash, then press “power +” or “”Power-” button to adjust the ultrasonic
power you need.
6.
Ultrasonic Cleaning modes: Common
,
Degas
,
Pulse
,
Turbo Sweep
,
Power Sweep
. Five cleaning modes can be chosen to clean different stuffs.
7.
Ultrasonic switch
:
Press it to start ultrasonic ,Press it again to be pause state.
