8 | AC10G(H) man.
UNPACKING
After unpacking the unit, inspect carefully for any damage that may have occurred during transit.
Make sure to tighten fittings, bolts, etc., before putting the unit into service.
WARNING! Do not operate this product if damaged during shipping, handling, or use.
Damage may result in bursting and cause injury or property damage.
GENERAL SAFETY INFORMATION
Since the air compressor and other components (material pump, spray guns, filters, lubricators,
hoses, etc.) used, make up a high-pressure pumping system, the following safety precautions
must be observed at all times:
1.
Follow all local electrical and safety codes as well as in the US, National Electrical
Codes (NEC) and Occupational Safety and Health Act (OSHA).
2.
Only persons well acquainted with these rules of safe operation should be allowed to
use this product.
3.
Keep visitors away and NEVER allow children in the work area.
WARNING! RISK FROM FLYING OBJECTS: Always wear approved
safety glasses with side shields when the air compressor is in use. Turn
off the air compressor and drain the air tank before performing any type
of maintenance or disassembly of the hoses or fittings. Never point any
nozzle or sprayer toward any part of the body or at other people or
animals.
4.
Wear safety glasses and use hearing protection when operating the pump or unit.
5.
Do not stand on or use the pump or unit as a handhold.
6.
Before each use, inspect compressed air system and electrical components for signs of
damage, deterioration, weakness or leakage. Repair or replace defective items before
using.
7.
Check all fasteners at frequent intervals for proper tightness.
DANGER! RISK TO BREATHING: Avoid using the air compressor in
confined areas. Always have adequate space (12”/30cm) on all sides of
the air compressor. Keep children, pets, and others out of the area of
operation. This unit does not provide breathable air for anyone or any
auxiliary breathing device. Spraying material will always need to be
in another area away from the air compressor to not allow intake air to damage the air
compressor filter. This compressor is not equipped and should not be used “as is” to supply
breathing quality air. For any application of air for human consumption, the air compressor
will need to be fitted with suitable in-line safety and alarm equipment. This additional
equipment is necessary to properly filter and purify the air to meet minimal specifications for
Grade D breathing as described in Compressed Gas Association Commodity Specification
G7.1-1966, OSHA 29 CFR 1910.134, and/or Canadian Standards Associations (CSA).
ENGLISH
Summary of Contents for AC10G
