v.220314
| 15
STEP 3: FENDER BRACKETS & DRAW BAR
Insert the two M14 x 95mm bolts from inside through the springs, nuts, washers, and fender
L-brackets, then tighten just until the spring is secure. Do not over-tighten, since the brackets
will need adjustment to the fenders later and may collapse spring channel.
Place the tongue tube between the two draw bar reinforcement brackets by using M14 x 85mm
bolts.
Install the coupler and safety chains using the M10 x 80mm bolts and M10 lock nuts provided.
The front bolt passes through the end link of the safety chain as it is inserted through the
tongue tubes. Tighten both bolts.
ENGLISH
Summary of Contents for MMT4X6OG
