DLI 8400 PRODUCT MANUAL
PAGE 47/49
Rev. 3
The CE Mark on the product indicates that the system has been tested to and
conforms to the provisions noted within the 89/336/EEC Electromagnetic Compatibility Directive
and the 73/23/EEC and 93/68/EEC Low Voltage Directive.
For further information, please contact:
Data Ltd. Inc.
703 Data Ltd Parkway
P.O. Box 761
La Porte, IN 46352 USA
(800) 526-1299
Data Ltd. Inc. shall not be liable for use of our product with equipment (i.e., power supplies,
personal computers, etc.) that is not CE marked and does not comply with the Low Voltage
Directive
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions. The user may find the following booklet he
lpful: “Something About
Interfere
nce.” This is available at FCC local regional offices. Our company is not responsible for
any radio or television interference caused by unauthorized modifications of this equipment or the
substitution or attachment of connecting cables and equipment other than those specified by our
company. The correction is the responsibility of the user. Use only shielded data cables with this
system. In accordance with FCC 15.21, changes or modifications not expressly approved by the
party responsible for compliance could void the user
’s authority to operate the equipment.
This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter. To maintain compliance with FCC RF
exposure guidelines for body-worn operation, do not use accessories that
contain metallic components.
When using accessories where the terminal is worn on the body, the terminal
’s touch screen
must face away from the body.
Summary of Contents for 8400
Page 1: ...Rev 3 ...
