Mounting
64
Manual
DLoG X Series
7.6.
Cable cover (Splash guard)
For safety reasons, the supplied cable cover for the external ports
must be installed prior to using the DLoG X device.
7.6.1.
Protection class IP65
In order to comply with protection class IP65, please use the optionally available IP65
assembly kit from DLoG. Please observe the installation instructions included with this
assembly kit.
After finishing the mounting process the cables must be affixed using the included strain
relief rail or strain relief clamp.
7.6.2.
Protection class IP54
To ensure that the DLoG X devices continues to conform to this protection category,
proceed as follows:
1.
Place the cables connected to and from the device next to each other. Avoid
crossing the cables.
2.
Attach the cables to the strain relief rail using the enclosed strain relievers or strain
relief clamp. Ensure that the cables are attached exactly where the cable cover’s
cable opening is located.
3.
Now attach the sealing ends onto the cables.
Take care not to damage the opening seal of the cable cover!
It should be possible to attach the cable cover to the cable duct
without using force.
The neck collar screws should be screwed firmly, preferably
diagonally and always using 5 rotations.
The screws need to be retightened after 2 days.
Summary of Contents for DLoG X 10
