Initial operation
28
User’s Manual
DLoG ITC 7
5.5.
Removing the protective film
The front of the DLoG ITC 7 is protected during transport by a transparent film. This film
should remain on the front during assembly to avoid damage to the display surface.
Only remove the film once all of the assembly work has been completed.
5.6.
Powering up the DLoG ITC 7
Only power up the DLoG ITC 7 after connecting all of the devices.
The DLoG ITC 7 is powered up by connecting it to an appropriate power supply and
then, depending on the version of the device, either using the
Power
switch.
Caution:
Property
damage
Make sure there is a suitable disconnecting device such as a
power switch or circuit breaker in the power supply circuit.
5.6.1.
Avoid contact with touch screen during booting
While booting the DLoG ITC 7 the touch screen may not be touched.
