Installation
Your PS10 subwoofer has a single 4 ohm
voice coil. How to connect the subwoofer
depends on what type of amplifier you use
and it´s optimum load. The best way to do a
correct connection is to follow the instruc-
tions given in the manual for the amplifier.
Most amplifiers today have built-in low pass
crossover and possibilities to connect your
subwoofer in bridge mode.
When designing a subwoofer system,
consider the following:
Subwoofers being used in the same
enclosure or powered by the same
amplifier should be identical.
Do not
use
different types of subwoofers that will
play in the same frequency range.
If you are designing a multiple sub-
woofer system, be sure to configure the
subwoofers so that they each receive the
same amount of power from the
amplifier.
Do not
mix serial and parallel connected
woofers, voice coils or pairs. If you plan
to use an odd number of subwoofers, be
sure to connect all the woofers in either
series or parallel connection.
For wiring, use high class speaker wires,
min AWG13 (2.5 mm²).
•
•
•
•
Wiring diagram
Warning!
Do not expose your amplifier to
loads below the manufacturer’s recommen-
dations. Below you will find some examples
of different connection types. Use the
following examples to determine the
required impedance load of your connec-
tion.
Parallel connection
One 4 Ohm subwoofer = 4 Ohm load
2
4 Ohm
4 Ohm
Summary of Contents for CS-PS10
Page 1: ...User manual 10 slim subwoofer ...
Page 12: ......
