Step 69.
Hook the screen tool to each
end of the screen at the lap
and tap the screen gently with
a rubber hammer or broom
handle. The tapping allows the
screen tool to tighten the
screens securely around the
drum. See Photo 64.
Attach the outside drum screen straps by
placing a strap over each end of screen. Be
sure strap splice is directly over a tumbling
bar, preferably a different tumbling bar than
where the screen itself is spliced. Securely
tighten the straps that are on the ends of the
screen and over drum rings.
WHEN INSTALLING OUTSIDE SCREENS,
ANY PORTION OF SCREEN THAT LAPS
MORE THAN SIX INCHES SHOULD BE
CUT OFF.
Photo 64
Step 70.
Remove the screen tool and continue to place the remainder of the straps
around the drum. Do not overtighten the straps that are placed in the center of
the drum as they could bend the tumbling bars and cause the screens to come
off. The straps for the center of the drum are only there to carry the weight of
the grain when in use.
Repeat the same process for
the second section of drum.
Straps needed for Model 54 are:
3’ sections 4 straps
2’ sections 3 straps
Connect straps with 1/4’ x 2-1/2”
round head machine screws.
Photo 65
19
DRAWING SHOWING DISCHARGE END OF DRUM
DRUM FULLY SCREENED NOTICE
Screen lap and strap splice do not
come on same tumbling bar.
Summary of Contents for Hi Cap 54
