9800 Series Keypad Installation Guide
5
Keypad Serial Number
For your convenience, an additional pre-printed serial number label is included. Prior to
installing the device, record the serial number or place the pre-printed serial number
label on the panel programming sheet. This number is required during programming.
The keypads can be programmed into the control panel by entering the serial number
in Device Setup panel programming, or alternatively using the wireless keypad
association operation. A maximum of 4 keypads may be used with the panel.
Installing the Keypad
The 9862 keypad housing is designed to easily install on any single-gang switch box or
flat surface. Figure 9 shows the keypad housing base mounting hole locations.
Selecting the Proper Location
9800 Series Wireless Graphic Touchscreen Keypads provide
a built-in survey capability in the Installer Options menu to
allow one person to confirm keypad communication with
the panel. See Accessing Keypad Wireless Survey later in
this document.
Remove the Cover
The keypad housing is made up of two parts: the cover,
which contains the circuit board and components, and the
base. Use the following steps to separate the keypad cover
and base:
1.
Insert a flat screwdriver into one of the slots on the
bottom of the keypad and gently lift the screwdriver
handle toward you while pulling the halves apart.
Repeat with the other slot. See Figure 8.
2. Using your hands, gently separate the front from the
base and set the cover and components aside.
9862
Series
Graphic
Keypad
Building Wall
Insert small
screwdriver and
lift
to remove
cover.
Do not twist.
Figure 8: Removing
the Keypad Cover
