Digital Monitoring Products, Inc. | 7400 Series Thinline™ Keypad Installation and Programming Guide
17
Card Format Number
Select the slot number (1-8) that you want to program for a
custom non-DMP card format. The format that is programmed
into slot 1 is the default format. In the event that a card with
an unrecognized format is used, that card will be read in the
format that is programmed in slot 1. To restrict card reads to
specific formats, only program slots 2-8.
See Table 2
for some publicly available
card formats that can be used with the keypad. Other private
or custom formats may also be compatible. Please contact the
credential supplier or manufacturer for the bit structure.
Note:
If you select slot 1 and you are upgrading from XR
panel version 182 or earlier,
FORMAT NAME
will
automatically be named
SINGLE CARD FORMAT
and
WIEGAND CODE LENGTH
will default to
45
.
Format Name
Press any select area to rename the card format. Press
CMD
to
save and advance.
CARD FORMATS
FORMAT NO: -
FORMAT NAME
*UNUSED*
Summary of Contents for Thinline 7463
Page 2: ......
Page 39: ......
Page 40: ...LT 2006 1 01 20113 2020 Digital Monitoring Products Inc...
