ISO 9001:2008 Certified Company
Tel./Fax : +359
64 801 597
e-mail :
office@dm-teh.com
web : www.dm-teh.com
Address : Pleven,Bulgaria
5800
34 “Gen. Lt. Atanas Stefanov” Str.
INSTRUCTION MANUAL
POWER SUPPLY
TYPE
FP9000 P
GENERAL DESCRIPTION
Power supply, type FP9000 P is an independent feeding device of combined type
– back up battery and battery
charger.
Its function is to ensure continuous power supply for devices in fire-alarming and fire-detecting installations and
automation of the fire protection equipment.
The feeder complies with the provisions set in the European Standard EN 54-4.
FP9000 P consists of:
− feeding module ;
− two back up batteries; The back up batteries are not included in the content of the delivery.
− Connecting terminals and a fuser 220V
The power supply front panel provides indication for the following conditions:
− Duty Mode (green LED)
− Fault condition (yellow LED). The fault condition could be mains voltage failure 220V or interrupted fuse AC; fault
or missing back up battery; interrupted fuse ACU; interrupted fuse User ;
– Low battery, back up battery or interrupted fuse ACU (yellow LED);
– mains voltage failure 220V AC or interrupted fuse AC (yellow LED);
– interrupted fuse User (yellow LED).
Upon fault condition the relay output is switched, too.
On the supply module the following terminals are located for connection to:
− the relay contacts for fault condition;
− voltage terminal 28V / 2.0A ;
TECHNICAL DATA
− Input voltage:
- (187-253)V AC, 50 / 60 Hz
− Maximum current consumption
- 56
VА
− Output voltage
- (17-27.6)V DC
− Output current
- 2.0
А
− Maximum output current
-
3.5А for 15 minutes
− Middle charging current
-
0.8А
− Overcharging protection
- at voltage < 17V
− Output for fault condition
-
relay, potential free switching, 1А / 30V DC
− Maximum section of the connecting wires
- 2,5 mm2
