PIDC0F0: MONOSTABLE TIME
Setting the monostable pulse duration
The relays used in the 5202R-EP work in bistable mode; that
is: when (and as long as) triggered, they remein in active
state.
the function cen be reverted to monostable mode (pulse con-
tact mode), and the contact closure time can be set using the
function C0F0.
Parameter: <Slot number> <Monotime>
where:
Slot number = 0001: Slot no. 1
Slot number = 0002: Slot no. 2
Slot number = FFFF: all
Monotime: $01...$7F (25ms steps)
$FF: bistable Mode
Press GET to display the current setting.
Example: both outputs are set to bistable
mode (default)
To set output 2 to monostable mode using
a pulse dauration of 0.4 sec (400msec),
enter:
0002 10 (hex)
10hex = 16dez, 16*25ms = 400ms
Press SET to write data.
Verify:
Press GET to read current data.
Relay 2 will now operate in monostable
mode using a pulse duration of 0.4 sec.
