Unpacking
Please unpack carefully and check that all items are intact. When leaving our factory, the interface
has been in good condition. In case of damage during transport please notify the carrier immediate-
ly. Please note that specific deadlines may apply to claim transport damages. We will only be able
to replace goods damaged during transit if we receive a written and signed confirmation issued by
the freight forwarder. Make sure you receive such a document and send to us a.s.a.p.
When unpacking, you should identify these items:
*
the interface 5202R-EP
*
a LCD display 3008P-SD
(only contained in 5202R-KIT)
*
a XLR connector board 5202R-AP (only contained in 5202R-KIT)
*
this manual
Please note that a start address programming adaptor (3006P-SD or 3008P-SD) is NOT included
(except 5202R-KIT).
All settings can be performed using DMX RDM
. Alternatively, a programm-
ing adaptor, which can be used to set DMX start address, DMX personality and DMX HOLD mode,
must be ordered separately
. If you already have it, there is no need to buy again: the start add-
ress board can be used for many of our DMX interfaces, pcb and DIN rail mount alike.
Cage Clamp Connectors
The decoder SWINGC4 consists of 6 terminal blocks. Termin-
als are based on screwless WAGO cage clamp technology,
which prevents loose connections and guarantees safe elect-
rical contact at all times. Use a standard
flat blade
screw dri-
ver and press the lever to open the terminal, insert wire and
release. Do
not
use a philipps or pozidrive screwdriver to pre-
vent damage ! Though both, solid and stranded wires may be
used we recommend to use stranded wires in combination
with isolated ferrules whenever possible.
SI
Peugruppe verwendet empfindliche elektronische Kompo-
nente
Please refer to the connector location outlined on next page.
Applications
The DMX relay 5202R-EP is intended to control stage lighting effects. A additional DMX data slot
can be used as common trigger to enable synchronized effects or secure the system against un-
wanted trigger.
IMPORTANT NOTICE
The control protocol DMX512 is not intended to control scenery or effects which could be hazar-
dous to man or materials (see standard ANSI E-11 DMX512-A, available from
www.ansi.org
). This
restriction must be similarly applied to previous standards USITT DMX512/1990, DMX56930-2 or
standards based on E1-11, such as ANSI E1-20 DMX RDM.
DMX512 does not contain any mechanisms or procedures that allow instant system shutdown in
