13
DISMANTLING KEY PARTS
5. DISMANTLING THE MOTOR ASSEMBLY
5.1 Dismantling the Turn Motor Assembly
5.2 Dismantling the Stepping Motor Assembly
1
5
KJJ46271
-003 x5
(TSS0233)
Clamp
Insert the
connector
Lead the wire from underneath
the card edge holder
[Before Installation]
• Check wiring (See Figure 1)
• Adjust position of wire of the turnover unit (See Figure 2)
• Check cam position (See Figure 3)
[During Installation]
• Ensure that wires are not trapped in the shaft
• Ensure that wires are not caught
Before installing the turn motor unit,
turn the turnover unit and ensure that
the wire is located on the left as
shown in the diagram.
Figure 2
Clamp the wire that is
guided through the bush
R
Be careful not to
catch the wires
Upon installing the turn motor assembly,
check by turning the jog dial to ensure
that the turnover unit rotates.
4
5
6
7
19 KJJ46271-003 x2
21
QYYASPW4006F
22
Lock the screws upon
fastening.
Perform secondary
tightening on the screws
(torque: 1.96 - 2.35 N.m)
23
QYSPSP
4008N x3
(126)
Shaft and Face 1
Shaft and Face 1
Fasten screws on the flat
surface of the shaft
STEPPING MOTOR SA
[Procedures for Fastening Screws on the Stepping Motor]
1) Tighten the screws temporarily to the main unit, and
tighten using a driver as shown in Figure 3.
2) After tension is properly adjusted, tighten the screws fully.
Hang the driver
on the notch
Use BKT as the
point of support
Figure 3
Figure 1
Tightening the Belt
All manuals and user guides at all-guides.com
