background image

Preparing the System for First Use

Prepping the Camera

1.  The camera battery must be charged before use. Use the supplied battery 

charger and allow at least 2 hours to fully charge.

2.  Clean the LCD surface on the back of the camera. Apply the 

guideline sticker to the camera LCD surface (shown in blue at 

right). The guideline helps to ensure the proper placement of 

your subject when taking ID photos.

3.  Power ON the camera (red arrow at right):

 

a.  Select a desired language.

 

b.  Select a desired location by following 

the on screen instructions, and then 

press the ● on the control button.

 

c.  Set [Date & Time format], [Summer 

Time], and [Date & Time] then select [OK] → [OK].

 

d.  Set the camera image size to 

5-Meg

 and the ratio to 

4:3

.

4.  Slide the bottom cover to open the SD card slot. Insert the Camera SD card 

(labeled “

C

”) into the card slot and click it into place. Close the SD card cover.

Prepping the Printer

1.  Power ON the printer.

2.  It takes about 25 seconds for the green light on the printer to blink, showing 

you have a good connection/signal strength.

Selecting the Printer Settings

1.  Press the MENU button.
2.  Press the DOWN arrow on the control button to display [ID PHOTO LAYOUT] 

on the LCD display.

3.  Press the RIGHT arrow. The layout names appear. 
4.  Press UP and DOWN to select the correct country option (for example, USA 

PASSPORT is selected for United States passport photos). Press the EXEC 

button to save your changes.

5.  The selected layout name appears under [READY]. 

NOTE

:  

If the antenna icon appears instead, press UP or DOWN to display the layout 

name.

6.  Press the MENU button. 
7.  Scroll to the COLOR ADJUST option and press the RIGHT ARROW button. 
8.  On COLOR ADJUST COLOR press the RIGHT arrow again.
9.  Use the DOWN arrows to select SHARPNESS. Use the LEFT and RIGHT arrows 

to change the setting to +2. 

10. Scroll down again to the GAMMA setting. Use the LEFT and RIGHT arrows to 

change the setting to +1. 

11. Press the DOWN arrow to select SAVE SETTINGS and press the EXEC button.

ID400 DC3 Installation Guide

© 2014 DNP IMS America Corp. All rights reserved.  

 

www.dnpphoto.com 

Reproduction in whole or part without written permission is prohibited.  

 

DOC-I-ID400-DC3 

Specifications subject to change without notice. 

 

Rev: 06.2014

MENU

MOVIE

W        T

>

Reviews: