Installation guide
6
dnp Supernova™
Flex Classic
2.
Attach Plate.B to Plate.C using Screw.D. Measure the distance between the two Plate.A pieces (installed on the wall in the
previous step) and space the Plate.B pieces the same distance apart then tighten Screw.D.
Note: Plate.C (x2) are not in the parts kit. They are already installed in the groove of screen case.
Plate.C
Screen case
Plate.C
Screw.D
Screw.G
Plate.B
Ensure that all Screw.Ds are tightened securely
Screen installation on wall
Make sure that you are at least two
people to do the screen installation.
1.
Attach Plate.A to the wall using appropriate fasteners (Screw.F can
be used). Measure the length of the screen case and install the
plates far enough apart so that the plates will be near the ends of
the screen when it is installed. We recommend that the center of
Plate.A is not further than 200 mm from the end of the screen case.
The plates must be lined up parallel to each other to ensure proper
operation of the screen.
Wall
Safety wire
Safety screw
Screw.E
Wall
Screw.F
Screw.F
Plate.A
Up
Slide
Wall
Screw.G
Screen case
Plate.A
Plate.B
(For installation on ceiling, please go to page 8)
