21. The heater must be handled with care, and avoid vibration
or hitting.
22. The heater must be securely grounded when in use.
23. If the heater gets damaged, it must be repaired by
professional electricians.
24. When assembling, keep away from any board or
flammable material.
25. The heater must be supervised by adults when it is used
by a child.
26. The heater is for household use only. It is not safe to use
on a building site, greenhouse, barn or stable where
there’s flammable dust.
27. The heater is at high temperature when in use. Unplug the
heater and wait until it cools down before cleaning.
28. Don’t use this heater in place where causticity or volatile
air exists, such as dust, steam, gas, etc.
29. Don’t use this heater as a cloth drier or towel drier.
30. Don’t use this heater as a sauna heater.
31. Don’t use this heater in place of animal propagating and
raising.
32. The heater should be plugged in a socket, which is easily
visible and reachable.
33. Do not use this heater with a programmer, timer, separate
remote-control system or any other device that switches
the heater on automatically, since a fire risk exist if the
heater is covered or positioned incorrectly.
34. Place the heater outside or in a large open area and well
away from any obstructions such as branches or where
the heater is close to any objects that can be affected by
heat, such as furniture, curtains or other inflammable
objects (minimum distance 1 meter).
35. The instruction manual shall provide adequate instructions
for connection to the supply ensuring an equivalent
protection!
Installation
The heater is built with the best quality components in
accordance to the prevailing legal regulations and certified for
safety in use. For best results from the appliance please ensure
that the installation is done by a qualified electrician in
accordance with the following instructions and taking full
account of current regulations. When using the heater, please
carefully follow the instructions and recommendations below.
You could loosen the two M6*10 screws by the ‘L’
hexagonal wrench to change the best Angle of heating.
Then retighten them.
