SE-0119 WIRELESS DOOR ALARM W/REMOTE
Magnetically Triggered Door Alarm And Remote Control
PACKAGE INCLUDES:
y
Main Unit ... 1PC
y
Magnetic Sensor ... 1PC
y
Remote Control ... 1PC
INSTALLATION:
y
Simply peel and stick the alarm to the door or any other place you wish to protect.
y
For best performance, keep the distance between the Main Unit and Magnetic Sensor no larger than half an inch.
y
The Magnetic Sensor can be installed on either side of the Main Unit. (see drawing below)
BATTERY INSTALLATION/ REPLACEMENT:
Main Unit :
y
Set the swtich to OFF and slide down the battery cover.
y
Follow the polarity instructions to insert 3 AAA Alkaline batteries (not included).
y
The red LED light will flash once if the batteries are installed correctly.
y
Put the battery cover back on.
Remote Control :
y
Unscrew the back cover to insert or replace replace 1 fresh CR2032 battery. Follow the polarity instructions.
y
Press any button on the remote Control. The red LED will light if the battery is installed correctly.
OPERATION:
Remote Mode :
y
Make sure the Magnetic Sensors are aligned and batteries are installed correctly.
y
After installing the batteries, slide the switch to , and the red LED will flash once.
y
Slide down the battery cover and press the small button beside the battery compartment once. A beep will sound, and the
red LED will flash for 5 seconds. The Main Unit is now waiting for the Remote Control to learn the code.
y
Press any button on the Remote Control and you’ll hear a Bi-Bi sound. This indicates the code has been learned successfully.
y
Press the ON button on the Remote Control, a Beep will sound, and the Main Unit will be armed in three seconds. The red
LED will flash three times.
y
Press the OFF button on the Remote Control, a Bi-Bi will sound, accompanied by a flashing red LED. The device is now
disarmed.
y
Under ARM status, once the door is opened, the alarm will go off continuously for 30 seconds.
y
Turn off the alarm by pressing the OFF button on the Remote Control or slide the switch to OFF on the Main Unit.
Manual Mode :
y
Make sure the Magnetic Sensors are aligned and that the batteries are installed correctly.
y
Slide the switch to
, and the Main Unit will be armed in three seconds and the red LED will flash three times.
y
Once the door is opened, the alarm will go off continuously for 30 seconds.
y
Turn off the alarm by sliding the switch to OFF.
NOTES:
y
The Magnetic Sensor can be installed on either side of the Main Unit, to allow for doors that open from the left or the right.
y
Please replace with new batteries if the red LED on the Main Unit flashes at 10 second intervals, or the Remote Control range
becomes obviously shorter.
WARNING:
The high pitched alarm sound may injure hearing if in close proximity to the ears. This alarm contains small parts and is not suitable
for children.
DISCLAIMER:
All Doberman Security items are strenuously tested by our experienced R&D teams. Doberman, however, does not guarantee that
this item will prevent all theft and/or attacks from occurring. This item is only meant to act as an alarm in emergency situations.
LIMITED WARRANTY COVERAGE:
If your product does not work properly because of a defect in materials or workmanship, Doberman will, for the length of the period
as follows, which starts with the date of original purchase (“warranty period”), replace it with a new or a refurbished product.
