Dobinsons Springs and Suspension
6.
Remove the foam bumper support,
aluminium bumper mount, aluminium crush
can mounts (keep the bolts nuts), the bumper
support brackets and the tow hooks.
7.
Install the chassis bracket to the chassis. This
will require the plastic air dams to be trimmed
with an air-hacksaw or similar to allow
clearance to the bracket.
8.
The Original flange nuts can be used on the
chassis studs. Re-install the tow hooks under
the chassis bracket. With everything loose
centralise the bracket and tighten all
fasteners.
9.
The longer flat plates can be fitted later –
these are the outer bulbar winch supports as
seen in the picture above. It is best to leave
these off for now until the bullbar is fitted.
10.
Take the template from the end of this
manual and first measure the scale line on
each sheet to ensure each sheet has been
printed at the full size, not scaled down. If this
is not correct contact your dealer for another
copy.
11.
Once confirmed hold the 2 pages against a
window so you can align both alignment
marks directly on top of each other and tape
together. Cut out the template.
12.
Tape the outer edges of the bumper to
prevent scratching and to allow a suitable
Summary of Contents for BU59-3545
Page 10: ......
