DocaPole 30ft GoSaw Kit Assembly Instructions
1.
To adjust extension pole length, raise thumb levers and pull out pole
segments to desired length, then lower thumb levers to lock into
place
2.
Extend and use the lower pole segments first if full extension is not
required. These segments are thicker and stronger and will provide
the best sawing experience.
3.
To minimize pole bend when not using at full extension, leave about
6” of overlap between pole segments by not extending them all the
way.
4.
Let the GoSaw's sharp teeth do the work. Focus on the saw's up and
down motion and not on trying to press the saw into the wood.
5.
.)
Only screw the GoSaw onto the pole’s metal tip. Some poles come
with a separate plastic hinge tip. This plastic tip is perfect for use
with cleaning attachments but is not intended for tree pruning.
6.
After screwing the GoSaw onto the pole, use a screwdriver to tighten
the locking screw at the base of the GoSaw. This will further secure
the GoSaw onto the end of the pole.
7.
If any pole segments begin to slip, use a screwdriver to tighten the
locking clasps on the pole. These can be adjusted as needed to
increase or reduce tension.
