7
Removing USB cable
1
Press the USB cable's release buttons on both sides of the connector (
a
) and
remove the connector from FOMA terminal (
b
).
2
Remove the USB cable out from the PC.
INFORMATION
･
Be careful not to give excessive force to the connecter of the USB cable when connecting/disconnecting the cable
to/from FOMA terminal. When disconnecting the connector, be sure to pull it straight while pressing the release
button. Applying an excessive force to disconnect the connector may give damage to it.
･
Do not remove the USB cable during data communication. The data communication is disconnected and it may
cause data loss or malfunction.
Installing FOMA communication configuration file
(driver)
To make data communication by connecting FOMA terminal and a PC with USB cable, FOMA
communication configuration file (driver) is required. Install the file before connecting FOMA
terminal for the first time to the PC.
To install the file, use the menu in the attached CD-ROM, or specify the folder in the CD-ROM
and perform manually.
I
Before operating, refer to "Precautions for installation/uninstallation".
→
P6
I
For Bluetooth connection, installing FOMA communication configuration file is not required.
Installing from the menu in the attached CD-ROM
I
Do not connect FOMA terminal until a message that instructs you to connect FOMA terminal to a PC
appears in Step 5.
<Example> Installing the driver under Windows Vista
1
Insert the CD-ROM into the PC's CD-ROM drive.
a
b
Connector
Release button
