21
Ba
si
c O
p
e
ra
tio
n
While using the detached keypad unit, HID support device (for key
entering) or HFP and HSP support device (for call) cannot be used
at the same time. To use those Bluetooth devices, perform any of
following procedures.
【
Procedure 1
】
Join the keypad unit and the display unit (available when Action
when detached is set to "Auto connected").
【
Procedure 2
】
When the keypad unit is detached,
m
e
f
*
b
e
move the
cursor to "F04B-S" on the device list,
m
d
to disconnect the
connection of keypad unit, then select a Bluetooth device to use
and connect it. Note that this operation turns OFF the power of
keypad unit.
Point
･
Please confirm the power of the keypad unit OFF after turning the power
of display unit OFF in areas where use is prohibited, such as in airplanes
and hospitals.
･
When Action when detached is set to "Always connected", battery power
consumes much.
･
When you detach the keypad unit while using HFP/HSP/HID device, some
keypad functions are unavailable because those profiles cannot be used
at the same time. While using HFP or HSP device, key operation by the
keypad unit is available and while using HID device, only voice call with
keypad unit is available. When you detach the keypad unit while using two
Bluetooth devices at the same time, the power of keypad unit turns OFF.
Simultaneous use of Bluetooth device
when separating
Before Using
Attaching UIM (FOMA card)/battery pack
Set UIM (FOMA card) to the display unit. For attaching/removing
the battery pack or UIM, separate the FOMA terminal, turn off the
power of display unit and perform properly with holding the
display unit in hand.
✜
Removing Back Cover F45
With pressing the back cover with your thumb, slide approximately 3
mm in the direction of the arrow to remove it.
✜
Installing UIM
Pull the tab with your nail and pull out the tray until it clicks (
a
). Hold
UIM with the IC side up, align the beveled corner with the tray (
b
)
and push into the tray until it stops (
c
).
Attaching to display unit
Press here with your thumb
Back cover
IC
Corner cut
UIM
Tray
Tab
