155
i-mode/i-motion
･
Sound effect setting is not reflected to MessageR/F.
･
If you set Use phone information to "Yes", the battery level,
Received signal level, time information, Melody effect
sound in Adjust volume, Select language and model
information may be sent to IPs (Information Providers),
causing such information to be known by the third party.
Using Message Service
Receive MessageR/F
When MessageR/F is received
･
Maximum number of saved items
→
P334
1
Receive MessageR/F.
and
(blue) or
(green) blink and "Receiving
messages
}
" appears.
MessageR/F ring alert, the light and light of round
illumination panel is lit/flashed and the reception
result screen appears.
The received MessageR is saved in "MessageR"
folder. The received MessageF is saved in
"MessageF" folder.
･
While receiving MessageR/F,
g
: Cancel
receiving
It may be received depending on the receiving
conditions.
a
Icon
(blue) : Unread MessageR exists
(green) : Unread MessageF exists
b
Reception result ticker
c
The number of received MessageR/F
･
The contents of unread MessageR/F appears after
the reception result screen appears, and if you do
not press any key for about 15 seconds, the
previous screen reappears.
When reception has failed
"
u
" appears on the right side of "Message R" or
"Message F" on the reception result screen. To
receive again, perform i-mode message.
✔
INFORMATION
･
When multiple mail and/or MessageR/F are received at the
same time, the terminal operates depending on the
conditions set for the mail or MessageR/F received last.
･
When MessageR/F is received, the MessageR/F in the i-
mode Center is deleted.
･
In the cases below, received MessageR/F is stored in the i-
mode Center.
- When the power is OFF
- During a videophone call
- Safety alarm is ON (Sending location, sending voice)
- Silent alarm is ON (Sending location)
- Loss protection is ON (Sending location)
- Power OFF notice is ON
- In Omakase Lock
- In Self mode
- Accessing Data Center
- During FirstPass center connection
- When reception has failed
- Out of i-mode service area
- When receiving SMS
- In infrared communication
- When storage area is filled with MessageR/F unread or protected
･
When the memory is not enough or the maximum number
of saved items is reached, a new MessageR/F overwrites
the chronologically oldest message except for unprotected
unread messages.
･
If there is not enough storage space available because
storage is filled with unread and protected MessageR/F,
reception of MessageR/F is stopped,
(red) or
(red)
appears on the screen. To receive mails, displaying the
contents of unread MessageR/F (
→
P156), deleting
unnecessary MessageR/F (
→
P157) or unprotecting (
→
P157) is required.
･
If there are remaining MessageR/F in the i-mode Center,
or
appears. It may not appear even when there
are MessageR/F. When the i-mode Center reaches the
maximum number of mail items that can be stored, the icon
changes to
or
.
◆
Displaying new MessageR/F
1
On the reception result screen,
2
or
3
.
･
Press
1
to display i-mode mail.
2
Select MessageR/F.
･
Playing when a melody is attached
→
P189
Displaying MessageR/F
→
P156
Blinking
a
b
c
Receiving screen
Reception result screen
Summary of Contents for F-05A
