Docomo FOMA D905I Manual Download

Page: 20 / 513

Easy Search/Contents/Precautions

FOMA terminal

●

Avoid extremely high or low temperatures.
Use in an environment with a temperature of 5 to 35

and relative humidity of 45 to 85 %.

●

If the FOMA terminal is used near a radio, television or
general subscriber phone, it could affect such
equipment. Use the phone as far away from such
equipment as possible.

●

With regard to data stored in the FOMA terminal, keep it
separately in a memo, etc. so as not to permanently lose
important data.
NTT DoCoMo cannot be held responsible in any way for
the loss of stored data.

●

When you connect an external device to the external
connection terminal or earphone/microphone jack, do
not insert the connector at an angle. Also, do not pull the
connector while connected to the FOMA terminal.
Malfunction or damage may result.

●

Do not close the FOMA terminal with the strap held
inside.
Malfunction or damage may result.

●

It is normal for the FOMA terminal to become warm
during using or recharging. You can continue to use it
while warm.

●

Do not leave the camera in direct sunlight.
Elements may be discolored or baked.

●

For normal use, leave the cap on the earphone/
microphone jack, the external connection terminal and
the microSD memory card slot.
If the cap is off, dust or water may get in and malfunction
may result.

●

Do not use the FOMA terminal with the back cover
removed.
The batter pack may fall out, leading to equipment
failure or damage.

●

Do not attach an extremely thick sticker on the display or
the sides with keys.
Malfunction may result.

●

Do not attach a label or sticker on the back of the display
part.
The label or sticker may get caught when you open or
close the FOMA terminal and malfunction or damage
may result.

●

Do not remove a microSD memory card or turn off the
power of the FOMA terminal while using the microSD
memory card.
Data loss or malfunction may result.

Battery pack

●

The battery pack will gradually wear out.
Battery life depends on how you use the battery pack; it
is time to replace it when the usage time is very short
even though you fully charge it. The specified battery
pack can be purchased separately.

●

Recharge the battery pack in locations where the
ambient temperature is between 5

C and 35

●

When using for the first time or after a long period of non-
use, be sure to fully charge the battery pack before use.

●

The time of use provided by the battery pack depends
on the ambient conditions and the condition of the
battery pack itself.

●

Depending on usage, the battery pack may swell as it
nears the end of its life, but this will not cause a problem.

●

Do not store or leave the battery pack with no charge.
A reduction in battery performance and life may result.

Adapter (and charger)

●

Recharge the battery pack in a location where the
ambient temperature is between 5

C and 35

●

Do not recharge in the following locations:

･

Locations that are subject to high humidity, dust or
excessive vibration

･

Near general subscriber phones, TVs or radios

●

It is normal for the adapter (and charger) to become
warm during recharging. You can continue charging with
a warm adapter.

●

When the battery pack is recharged using the DC
adapter, always keep the car engine running.
Failure to do so could cause the car battery to run down
more quickly than normal.

●

When an outlet with falling prevention mechanism is
used, check the instruction manual of the outlet before
use.

●

Do not expose to the strong shock and deform the
recharging terminal.
Giving the strong shock on an adapter can cause
damage.

UIM (FOMA card)

●

Do not use excessive force when attaching or removing
the UIM.

●

The UIM becomes warm during use. This is normal and
not a cause for concern.

●

Note that any card failures resulting from inserting the
UIM in an IC card reader/writer not designated by NTT
DoCoMo are the responsibility of the customer.

●

Make sure that the ICs are kept clean.

●

Clean the UIM with a soft dry cloth (such as a lens cloth).

●

It is recommended that users maintain data stored on
the UIM in some other form.
If the data should be erased, NTT DoCoMo assumes no
responsibility for the loss of any data.

●

The UIMs that are no longer used should be returned to
a DoCoMo Shop for environmental protection.

●

Avoid extremely high or low temperature.

●

Take care not to damage, touch, or short-circuit the ICs
to prevent them from losing their data or from
malfunctioning.

●

Take care not to drop the UIM or give shock to the UIM
to prevent it from malfunctioning.

●

Do not bend the UIM and place heavy stuff on it to avoid
a failure.

●

Do not insert the UIM with a label or sticker attached in
the FOMA terminal to prevent it from malfunctioning.