Docomo FOMA D905I Manual Download

Page: 47 / 513

Voice/Videophone Calls

Entering pause “P” or timed pause “T”

The pause and timed pause are available only for voice

calls.

･

You cannot make a call if a pause is entered at the

beginning of the phone number.

When you press

after the call is connected, the

number after the pause is sent.

■

Entering a pause “P”:

(

after the phone

number (for over a second)

A pause is used for operating the answering system
at home, reserving tickets, etc. At the point the
pause is entered, the dialed digits are separated and
tone signals are sent.

■

Entering a timed pause “T”:

after the phone

number (for over a second)

A timed pause is used to dial an external number
followed by an extension number. Enter a timed
pause between the external and extension numbers.
The extension number will be called a certain
number of seconds after the external number.

･

Timed pauses can be entered in succession.

･

Each timed pause is followed by a second interval.

INFORMATION

●

Tone signals may not be received depending on the
receiving device.

●

You cannot make a call to another party by putting the
current call on hold and entering a pause or timed pause.

Switching between a voice call and
videophone call

You can switch between a voice call and a videophone

call by operating from the submenu during a call when

the other party’s terminal can also switch the call.

Switching can be performed only from the calling

terminal.

･

This operation is available between the terminals that

support switching between a voice call and

videophone call.

･

To switch the call, the other party needs to set

Indication ON

of Notify Switchable Mode in advance.

☛

P65

during a voice call

Yes

: Returns to the voice call talking screen.

･

A guidance informing that the call is being
switched is heard during switching.

･

When

Speakerphone

is set to

in Videophone

Settings, the speakerphone is turned on when
the call is switched to a videophone call.

■

Switching from videophone call to voice call:

during a videophone call

Yes

INFORMATION

●

When you are in packet communication, disconnect the
packet communication and switch to a videophone call.

●

When the other party is during packet communication,
the call cannot be switched to a videophone call.

●

During a voice call using Call Waiting Service, you
cannot switch the call to a videophone call.

●

It takes about 5 seconds to switch. It may take longer
depending on signal conditions.

●

Depending on signal conditions, a voice call and
videophone call may not be switched and the call may be
disconnected.

●

The speakerphone function is turned off when a
videophone call is switched to a voice call.

●

The settings (such as switching the cameras or selecting
the frame) made during a videophone call are canceled
when a videophone call is switched to a voice call.

●

According to the call duration of a voice call and
videophone call, the call charges are added up,
respectively.

●

The call is not charged while

Switching...

is displayed.

Example

Calling “03XXXXXXXXP12345”
(P=Entered pause)

Example

Switching from voice call to videophone call