59
e03_dv50_7e.fm
Voi
ce
/Vi
de
op
ho
ne Ca
lls
J
Enabling/Disabling Chaku-moji display
<Message display>
1
In stand-by, press
t
?
[Settings]
?
[Other NW Services]
?
[Chaku-moji]
?
[Message display]
?
select a display method.
Dialing with Chaku-moji Message
<Chaku-moji>
1
In stand-by, enter the other party’s phone number and press
C
?
[Chaku-moji].
In stand-by, press
a
, select a name, press
C
and select [Chaku-moji] when calling with Chaku-moji
from the phonebook.
2
Select a Chaku-moji message.
3
Press
s
(Phone)/
i
(V.phone).
Note
The ten most recently sent messages are recorded as Sent messages.
Even if a call is shorter than the set ringing time of the
Set mute ring time
, Chaku-moji is displayed and
charges are applied.
Depending on the signal strength, sending results may not be displayed even if the other party has received
Chaku-moji. In this case, charges are applied.
While
Function lock
is applied to Chaku-moji, terminal security code must be entered to select a
Chaku-moji message from the already saved Chaku-moji messages or the Sent messages.
For overseas usage, Chaku-moji cannot be sent/received.
On
Redial voice call
, Chaku-moji used when Videophone was dialed will be automatically sent.
Chaku-moji does not support PushTalk.
When the call recipient is in the following setting, Chaku-moji does not appear and transmission charges are
not incurred even if dialed with Chaku-moji.
When the recipient’s terminal does not support Chaku-moji
When a call is received from numbers rejected by the message display settings
In addition, when the call recipient is in the following setting or status, the send results do not appear on the
sender side display (Chaku-moji is not recorded in Received calls on the receiver side).
When outside the service area or the power is turned off
When Public mode (Drive mode) is set
When the answering duration for Record message is set to [0 seconds]
To create a new message
[Create message]
b
enter a Chaku-moji message and press
t
To select from saved Chaku-moji messages [Select message]
b
select a Chaku-moji message
To select from Sent messages
[Sent messages]
b
select a Chaku-moji message
To delete one Sent messages entry, select a Chaku-moji
message, press
C
and select [Delete one]
b
[Yes].
To delete all Sent messages entries, press
C
and select
[Delete all]
b
enter terminal security code and press
t
b
select [Yes].
If Chaku-moji reaches the recipient,
[Transmission completed] appears and
transmission charges are incurred.
dv50_e.book 59 ページ ２００７年１０月２９日 月曜日 午前１０時３８分
Summary of Contents for Foma SH905i
