53
Continued on next page
V
o
ic
e
/V
id
e
op
ho
ne
C
a
ll
s
z
If the videophone call is not connected, your call is
automatically switched to a voice call when you set
“Auto redial as voice” to “ON”. However, the call
may not be handled in this way if you call an ISDN
synchronous 64K, ISDN videophone which does
not support the 3G-324M standard (as of January,
200
8
) or if you dial a wrong number. Note that call
charge may be applied in some cases.
Switching a Voice/Videophone
Call During a Call (Caller)
z
You can use this function with the terminals
compatible with voice call/videophone call switch.
z
You can switch the voice call only when you are the
caller.
z
To switch the call, the receiver needs to set “Ntfy
switch-mode” to notify the switch beforehand.
→
p.72
<Example: To switch a voice call to a videophone
call>
1
In-call screen (p.50)
d
(V. phone)
“YES”
While switching, the screen which indicates that
the calls are being switched appears and the
voice guidance is played.
■
To switch a videophone call to a voice call
Videophone in-call screen (p.50)
u
(FUNC)
“Change to voice”
Set caller ID to ON
You connected without notifying
your caller ID (when dialing into
visualnet, etc.)
Your call is being
forwarded
The call is being forwarded (A
Videophone call is made when
the forwarding number is for a
3G-324M-compatible
videophone.)
Redial using voice
call
The phone for the forwarding
number is not compatible with
videophone calls.
Please activate
caller ID before
dialing again
The other party sets the Caller
ID request service.
At the user’s
request, your call
cannot be connected
The other party sets the
Nuisance call blocking service.
Upper limit has been
exceeded
Connection failed
The upper limit set for a Limit
billing plan (Type Limit and
Family Wide Limit) is exceeded.
Connection failed
Set the caller ID notification to
“ON” and retry
• This message may also
appear in other situations.
Please make your
call from the i-mode
web page
You attempted to make a
videophone call to watch V-live
without browsing the i-mode
official site.
Display
Cause
N
z
It takes about 5 seconds to switch the calls. Note that
the signal quality may affect how long it takes.
z
You cannot switch the calls during calling in the
following cases:
• When the other party is holding the call
• When the other party activates Record message
z
The displayed call duration is reset to 0 second each
time the calls are switched. However, the total time for
voice and videophone call is displayed after ending a
call.
The digital
communication fee
is charged after the
appearance of this
screen.
Summary of Contents for foma SO705i
