Scheduled Update of Software
If you want to schedule the installation of the
update file for a different time, you can set the
software update time in advance.
a
Display the notice screen
u
"Set
Time"
b
Enter the desired time
u
"OK"
When the scheduled time arrives
The installation screen is displayed at the
starting time, and the installation starts
automatically after approximately 3 seconds.
Note
• All key operations are disabled during the
update. The update cannot be stopped either.
• In case installing the software is not operated
at the preset time, it starts again at the same
time on the following day.
• In case OS version is being upgraded, the
software update does not start even if the
preset time arrives.
• In case alarm has been set at the same time
as the preset time, the software update
starts.
• In case L-02E is off at the preset time, the
software updates starts at the same time
after turning on.
• In case " The software update is interrupted.
Check the condition of this terminal, and start
again." is displayed on the status bar during
the software update, make sure that this
terminal is not in the following conditions, and
start the update again.
- No service
- Battery is detached
- Interference by other functions
- Insufficient memory of this terminal
- Insufficient battery
- Network error
- Writing failure
280
Appendix / Index
