202
Appendix/Index
Calls cannot be made from the terminal
connecting to external device such as car
navigation or handsfree device.
･
If calls are made several times when the
other party does not answer or is out of
service, the call to this number may be
disabled. In this case, turn terminal off and
on.
■
External device connection
An external device connected using
microUSB cable or MHL cable is not
recognized.
･
Remove the external device and then
connect it again, then [Detect USB
device]
u
[OK].
→
P.151
However, some devices may not be
detected.
■
Map/GPS
Cannot set AUTO-GPS service
information.
･
Check if the battery level is low and AUTO-
GPS function stops.
If AUTO-GPS stops due to "Low-power
operation settings", AUTO-GPS service
information cannot be set. In this case, set
"Low-power operation settings" to "Not
suspend" or charge the battery.
→
P.31,
P.164
･
Check if "AUTO-GPS operation settings" is
marked.
→
P.164
●
No service
･
The terminal is out of service area, or the
received signal is too weak. Move to a
location where radio signal can be
reached.
･
The docomo nano UIM card is not
working properly.
Insert the docomo nano UIM card in
another terminal. If this works, it is
probably the terminal that is causing the
problem. In this case, contact "Repairs" on
the last page of this manual (in Japanese
only).
Removing and inserting docomo nano
UIM card may solve the problem.
●
Mobile network not available
Install docomo nano UIM card correctly
(P.30), then move to a location where radio
signal reaches.
●
Normal calls are restricted by access
control.
Appears when normal voice call service is
hard to receive because communication
lines are busy.
●
Emergency calls are restricted by access
control.
Appears when emergency voice call service
is hard to receive because communication
lines are busy.
Error messages
Summary of Contents for SO-02H
Page 1: ...15 10 INSTRUCTION MANUAL...
