2 |
P a g e
NOTE: Not for use on ceilings over 12 feet.
The SGP
™
is not designed to be stacked on other poles to make it reach higher than it was designed to
from the factory.
Any modifications or changes made to the SGP
™
from its original design are not supported by Doc’s
Industries, Inc.
The SGP™ comes pre
-assembled and ready to use! Simply secure your screw gun following the
instructions in the “Securing a screw gun in the SGP™ casting” section on
page 3.
SGP
™
- General safety warnings:
•
Follow all safety instructions for the screw gun you are using with the SGP
™
.
•
Keep work area clean and well lit. Make sure there are no trip hazards such as electrical cords, step
stools or other power tools.
•
Do not operate tool in hazardous conditions.
•
Keep children and bystanders away while operating the tool.
•
Stay alert
–
do not use while tired or under the influence of drugs, alcohol or medication.
•
Always use eye protection and other protective equipment such as a dust mask, boots, hard hat and
hearing protection appropriate for the conditions.
•
Keep proper footing and balance at all times.
•
Do not force the tool - use the correct screw gun setting & fasteners for your application.
•
Be certain the screw gun is operating properly and is adjusted before lifting to the ceiling.
Most modern screw guns have a depth setting for the fastener and some include an automatic
trigger depression system.
•
Disconnect the power source before making any adjustments.
•
Maintain the SGP
™
- check for misalignment, binding or breakage of hose clamp or wire bale pin as
well as any other condition that may affect the tool during operation. If damaged, have the tool
repaired by a professional before use.
