6 |
P a g e
E.
Secure the screw gun in place using the provided 90
–
110 mm hose clamp. There are cut outs /
notches on the casting that indicate the proper placement of the hose clamp.
Use the SGP™
compatibility chart & Hose Clamp Location Charts on pg. 9 & 10 for proper placement. Make
sure your screw gun is properly seated in the casting before tightening the hose clamp. Do not
over-tighten.
F.
Check that the screw gun is parallel to the pole tool and casting. Check both horizontal and
vertical alignment of the screw gun. If not aligned properly, repeat step A.
