Assigning devices
The next step allows you to assign devices to the selected group. The
gateway identifies devices that have already been assigned by brighten-
ing them to their maximum value. Pressing ② and ③ selects a control
gear device which is identified by flashing and pressing ④ confirms it:
S e l e c t
d e v
E s c
-
0 7
+
!
O K
①
②
③
④
assignment status
*
The device is already assigned to the group.
!
The device is already assigned it to a different group.
After confirming the device number by pressing key ④, you can add the
currently selected device to the group (key ③) or, if it already exists,
remove it (key ②). In every case you are taken back to the above menu
item via which you can terminate the entire procedure.
D e v : 0 7
g r : 0 4
E s c
r e m
a d d
①
②
③
④
5.6.3 Configuring lighting groups
The following group parameters can be set separately for each lighting
group:
1. Minimum brightness down to which lighting should be dimmed
2. Maximum brightness up to which lighting should be brightened
3. Dimming speed during manual smooth adjustment of lighting
4. Fade speed when changing lighting scenes and issuing central
commands
L i g h t
g r o u p s
�
C o n f i g u r e
�
①
②
③
④
DE EN
23
