9
To change the stimulation level, the collar must be switched on (battery inserted):
Opening the battery cover gives you access to the push button indicated by an arrow (See Diagram #3).
To activate this push button, use a pointed object such as a pencil tip.
Number of beep sounds heard
when switching modes
Mode
Stimulation level
1 2 3
1 2 3
low stimulation levels:
for small dogs or dogs with sensitive temperament
4 5 6
4 5 6
medium stimulation levels:
for medium dogs or dogs with average temperament
7 8
7 8
strong stimulation levels:
for large dogs or dogs with stubborn temperament
In order to test the installation, proceed as follows:
•
Before doing so, make sure the transmitter is turned Of (blue indicator light Of).
•
Attach each wire of the neon test lamp under each contact point (unscrewing them lightly and
retightening them so as to pinch the test lamp wires).
•
Turn On the transmitter.
•
Set the warning and stimulation zones on the levels that seem appropriate.
•
Stand at the center of the authorized area holding the collar by the strap at the same height and
orientation as if on your dog’s neck. Then walk towards the edge of your property where the antenna
wire is laid. At a certain distance from the wire, the collar should emit beep sounds. Then, when you
carry on, the neon test lamp should light indicating stimulations are emitted. If you think the zones are
insuicient, go back to the transmitter to modify the settings.
•
Use the center dial (0 to 10) to modify the width of the stimulation zone and the 3 positions button
on the right to modify the correction zone (1 to 3). Check the new settings on your property. Test the
settings in a number of diferent areas of the installation to ensure that the functioning is constant.
•
When the zone setting is complete, walk all around the authorized area holding the collar by the
strap at the same height and orientation as if on your dog’s neck in order to check that there is no loss
of signal.
•
Before disconnecting the neon test lamp, make sure the transmitter is turned Of (blue indicator light
Of ).
WARNING:
Do not test or adjust the system while the collar is on your dog.
ADJUSTING THE STIMULATION LEVEL
8 stimulation levels (modes) are available on the collar so you can adjust it to your dog (size, sensitivity,
temperament).
In the factory, the collar is set on
mode 4.
Always start with a low level of stimulation and deine the level from which your dog reacts by
increasing gradually.
The table below indicates how your collar operates according to the selected mode:
Summary of Contents for EF-4000
Page 1: ......