- 6 -
<Operation Test>
· When testing after assembly, check the operation by touching the manual wash button.
· In case of water leakage or an emergency, quickly turn it off by pressing the power button.
· When water is sprayed on the defecation board, turn the nozzle by hand to adjust the
spray angle.
· When the sensor is activated, the green light flashes and water is sprayed after 2 minutes.
· When the washing water quantity increase switch is turned on, the spraying quantity
increases from 1,000cc to 1,500cc.
· In the case of direct type, when the increase switch is turned on, the spraying quantity is
increased two folds from 1,500 cc to 3,000 cc.
· It is normal for water to accumulate in the collecting channel and it serves as a sewer odor
backflow prevention trap.
· If the blue light is not turned-on after plugging in the sensor jack, press the power button to
reset again.
· The defecation board and main body work normally when it is horizontal, so if the floor is
sloped, use the rubber plate to level it
Assembly of the Main Body
Waste Water Container Connection
and Water Quantity Increase Switch
Lift the main body and place it
on the square collecting channel.
Put the silicone hook on the
bottom so that the lid does
not come off.
Insert the transparent inlet
pipe into the gray silicone for
about 1cm each.
Turn the lid and connect it to
the waste water container.
After plugging in the sensor jack,
connect the power jack from
the back.
There is a water quantity increase
switch and a power jack on
the back.
<3 Steps of Separation: 1.Power jack 2.Sensor jack 3.Inlet pipe>
Main Body assembly and
Operation Test
-
Stop for 3 seconds, then auto wash for 2nd time.
