- 8 -
<Precautions for Happyloo>
· When refilling the main body with water, empty the waste water container completely so t
hat it does not overflow.
· When the end of the discharge hose touches the sewage, the water flows back, so shorten
the length from the lid.
· Put a sticker for eaves on the top to prevent water from flowing into the button and sensor jack.
· Do not bend or fold the discharge hose, and beware of freezing in winter on the veranda.
· There are a lot of urinary stones, so clean the parts under the main body with a wet
tissue once a month.
· In case of a water container type other than a direct type, extending the discharge hose
may cause malfunction. If you want to extend the hose, place the end of the discharge
hose higher than the defecation board.
· If the main body overflows, it may cause malfunction. When replenishing water, fill it up to
just below the MAX so that it does not overflow to the side. This is because there is a
hole inside the cover through which the hose passes.
<Knowing Happyloo – Checking>
1. Before assembling the main body, use the rubber feet to properly level the defecation board.
2. When connecting the transparent inlet pipe to the gray silicone, insert only about 1cm.
3. When refilling the main body with water, empty the waste water container completely so
that it does not overflow.
4. The blue light is ready for automatic cleaning. When the sensor is detected, the green
light flashes and water is sprayed after 2 minutes.
5. Extend the discharge hose and, when the pump sound is loud during the initial operation,
and it spins, pull out the hose connection for a while and then plug it in again after the air
is exhausted. In the case of a water container type, place the end of the discharge hose at
a higher position than the defecation board.
6. When reducing the amount of washing water, turn the water quantity increase switch on
the back to OFF.
7. Attach the tape for eaves on the top to prevent water from flowing into the sensor jack.
8. If the water does not stop flowing from the nozzle of the defecation board, open the black
cover inside the water container and remove the debris from the air hole in the upper part
of the hose after operation.
9. When resetting, touch the power button or unplug the power jack and plug it back in.
10. When training the defecation, attach the mesh plate with tape to fix it.
11. When training the defecation, unplug the sensor jack and press the wash button to use.
hole inside the cover through which the hose passes.
Black button: wash Red button: power
Precautions and
Notes (Check)
