43
ENGLISH
WARNING:
If other receivers (dog handlers) are paired with your receiver, you will
no longer be able to track them after changing the channel. These hunters would
also have to switch their receivers and transmitters to the same channel.
8.1 Tracking
The transmitter (collar) and the receiver (handset) have built-in GPS receiver by
which both detect their position. The transmitter sends information about its positi-
on by means of the radio signal (RF) to the receiver, which shows the direction and
dog’s distance from the handler on the display.
Receiver display is divided into three parts:
Receiver information panel
– top line displays the receiver’s data – battery charge
status, GPS position accuracy, magnetic north direction (compass), switching on
the BEEPER and FENCE features relating to one of the paired dogs.
Main navigation panel
– middle display section provides information about the
currently selected transmitter (other receiver). Illuminated pointer arrow shows
the direction to the tracked dog location. In the middle of the display, distance
between the dog and the handler is shown. Different dogs are displayed by using
the / push buttons.
Transmitter information panel
– bottom line shows data relating to the next
paired transmitter in sequence – battery charge status, RF signal strength, GPS
position accuracy.
8
DOG GPS X30 FEATURES
NOTE:
If the dog’s direction and distance indicator flashes, the receiver has not
received the GPS data for a long time or the receiver/transmitter has no GPS
signal. In such case, the direction and distance to the last known position is
indicated on the display.
WARNING:
If the direction indicator does not point correctly towards your dog,
recalibrate the digital compass.
Status indicated on the receiver’s display:
– Receiver has not received information from the transmitter relating to
the dog's position for a long time.
– If the RF signal strength indicator flashes, it signifies that it has received
location data from the selected collar.
– If only the RF aerial flashes – it does not receive any RF signal from the transmitter.
6.
If the channel is changed correctly message will show on all transmitters’
displays. If the change fails, the
message will appear on the display.
Repeat the whole procedure from the step number 4.
7.
By repeatedly pressing return to the receiver’s main screen.
8.
Make sure that you receive RF signals from all your transmitters on your receiver. If
no, try switching the channel again to the desired receiver / .
