HELIX ONE Mk2 INSTALLATION & OPERATION GUIDE
11
DA-MAN-H1-001
www.dohmannaudio.com
* In the event that the Helix
* In the event that the Helix
* In the event that the Helix
* In the event that the Helix One
One
One
One is moved at a later date, the transport screw
is moved at a later date, the transport screw
is moved at a later date, the transport screw
is moved at a later date, the transport screwssss must be
must be
must be
must be screwed
screwed
screwed
screwed in even
in even
in even
in evenly in
ly in
ly in
ly in
the exact opposite process
the exact opposite process
the exact opposite process
the exact opposite process to the one described above. THIS
to the one described above. THIS
to the one described above. THIS
to the one described above. THIS MUST HAPPEN PRIOR TO ATTEMPTING TO MOVE
MUST HAPPEN PRIOR TO ATTEMPTING TO MOVE
MUST HAPPEN PRIOR TO ATTEMPTING TO MOVE
MUST HAPPEN PRIOR TO ATTEMPTING TO MOVE
THE TURNTABLE.
THE TURNTABLE.
THE TURNTABLE.
THE TURNTABLE.
* WARNING: If the turntable sustains damage due to a failure to comply with these instructions, the cost of
* WARNING: If the turntable sustains damage due to a failure to comply with these instructions, the cost of
* WARNING: If the turntable sustains damage due to a failure to comply with these instructions, the cost of
* WARNING: If the turntable sustains damage due to a failure to comply with these instructions, the cost of
repairs will not be covered by the Döhmann Audio Warranty p
repairs will not be covered by the Döhmann Audio Warranty p
repairs will not be covered by the Döhmann Audio Warranty p
repairs will not be covered by the Döhmann Audio Warranty policy.
olicy.
olicy.
olicy.
* Please retain the transport screws in the event the table must be moved at a later date.
STEP 5
Place a soft blanket or cloth on a flat surface to place the platter on. Remove the platter from the top
compartment solid foam and place it on the blanket with the bearing side up. Remove the soft plastic bearing
protector on the underside of the bearing to reveal the bearing assembly on the bottom of the platter.
Remove the soft plastic bearing protector from the inverted bearing post on the chassis.
STEP 6
Perform an initial levelling of the chassis by winding each of the four feet up or down. Use a bubble level on
the top plate of the chassis as a starting point. Visually check each foot to ensure that all four are firmly
connecting with the surface of the shelf that the turntable is placed on.
STEP 7
Fasten the record clamp to the spindle. The record clamp is the designed to also be the most secure handle to
move the platter into placement position. Check that the twin belts are sitting in the matching grooves on the
platter. Loop the supplied brightly coloured string (or any suitable string/cord) behind both belts to enable the
belts to be pulled over the motor spindle with ease.
DUAL BELTS
BEARING “BORE” UNDERSIDE