HELIX ONE Mk2 INSTALLATION & OPERATION GUIDE
9
DA-MAN-H1-001
www.dohmannaudio.com
STEP 3
Now it is time to open the top of the flight case to access the rest of the turntable parts. Undo the four piano
hinges that disconnect the top compartment and gently lift the top off the case.
The top compartment contains the platter, clamp, accessories, and the optional tonearm (if a tonearm was
ordered with the turntable). We hope that you enjoy our gift to you, the award winning Sullivans Cove single
malt whisky. We advise that for the sake of completing the turntable installation accurately, that you consume
it after, not prior to installation.
স
হ
The bearing assembly is transported pre-lubricated, attached to the turntable chassis. The platter assembly
comes complete with the upper bearing assembly which is precision matched to the inverted bearing post
found on the chassis.
A 6.35mm (1/4 inch) ball bearing is contained within the bearing housing. When mounting the platter to the
chassis platform please ensure the ball bearing is inside the inverted bearing post and has not dropped out in
shipping. If the ball bearing is missing, replacement ball bearings are available from your dealer.
The twin belts are also pre-installed on the platter from the factory for easy transport.
For ease of installation, a brightly coloured string is supplied to facilitate the quick and easy installation of the
belts over the pulley. Please note that any twine or cord approx. 30cm (12 inches) in length is suitable for this
purpose. The string is located under the record clamp with the bubble spirit level.
Twist the piano hinges – top compartment
Contents of the top compartment